Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance: Post-Motor Filter
1
Located on the front near the height
adjustment knob, remove filter door by
pressing and pulling latch downward.
3
Replace filter in unit with
handle facing you. Replace
the door by hooking the
bottom into the grooves
and rotate towards unit,
snapping into place.
WARNING
Do not operate vacuum with damp or wet filters, as well as without filters or the Dirt
Container in place. Allow components to dry before reassembling the Dirt Container.
Maintenance: Floor Brush Roll
1
Ensure vacuum is unplugged.
Place handle in low position,
remove hose from foot and
turn vacuum over bottom side
up. Remove 6 screws with a
Phillips head screwdriver. Lift
brush cover off of the vacuum.
NOTE: For ease of screw removal and replacement, use a magnetic Phillips screwdriver.
8
www.BISSELL.com
2
2
Grasp rotating floor
brush at both ends and
lift straight out of the
vacuum foot. Slip off
the belt.
Remove the filter by
grasping the handle
on the front of the
filter and pulling out
from vacuum. Clean
by tapping the filter
on the side of a trash
container or replace
filter, as necessary.
NOTE: The pleated post-
motor filter may NOT be
washed with water or
detergent. If dust and/or
debris accumulates on filter,
gently tap the filter on the
side of a garbage container.
3
Clean debris from rotating
floor brush, motor
pulley, drive belt and air
passageway areas.
Publicidad
