Publicidad
Idiomas disponibles
Idiomas disponibles
1.3 - INSTALLATION OF THE APPLIANCE
•
After removing the packaging, check that the appliance is in perfect condition; in case of doubts do not use it and
refer to professionally qualified personnel.
• Install the appliance on a rigid and levelled floor while keeping the room ventilated.
•
Place the appliance in a suitable environment.
Make sure that curtains or other objects don-t obstruct the air flow (Fig. 5).
•
Leave at least 20cm of free space on both sides and behind the appliance and leave at least 30cm of free space
above it (Fig. 1).
•
Remove the tank (7) and uncoil the supply cord (9).
•
Correctly reposition the tank (7) in the appliance body.
•
Insert the plug in the power socket; the appliance emits a "beep" and the display shows the percentage of hu-
midity in the room.
1.4 - CONTROL PANEL
ON/OFF key
Press this key to start the appliance.
Press it again to switch the appliance off (the fan still works for 1 minute, then it stops).
Voltage presence led
This led turns on in blue when the appliance is running.
Water tank full led
When the water tank is full, the led turns on in red, the appliance stops and the buzzer sounds
15 times to warn the user.
It is necessary to remove the tank (7) (figure 7) and to empty it.
Correctly reposition the tank in order to restart the appliance.
Timer key
With the appliance electrically powered but not running
press the key once or more to enter the function and set the switching on delay time (from 1
to 24 hours), the TIMER led flashes in blue.
EN - 17
Publicidad
