Publicidad
Idiomas disponibles
Idiomas disponibles
General description
The illustrations can be found on
the front and rear fold-out pages.
Scope of delivery
Unpack the equipment and check that it is
complete. Dispose of the packaging mate-
rial correctly.
• Appliance
• Sharpener for knives and scissors
• Sharpener for drills
• Sharpener for picks and chisels
• Spare grinding wheel
• Instruction Manual
Function description
The sharpening station is suitable for
sharpening tools (e.g. drills, knives, scis-
sors, picks, chisels). The scope of delivery
contains three sharpeners for this purpose,
which, as a guide and safety device, en-
able precise sharpening and grinding.
Refer to the following descriptions for a
functional description of the controls.
Summary
1 Mains plug
2 Sharpener for knives and scissors
3 On/off switch
4 Spacer
5 Magnet holder
6 Tool table
7 Retaining screw for
angular adjustment
8 Protective hood
9 Mounting holes for work bench
assembly
10 Grinding wheel
11 rotatable drill mount
12 Knurled nut for drill-fastening
13 Release lever for sharpener
14 Drill holder
15 Adjusting device
16 Grinding wheel nuts
Technical specifi cations
Tool sharpening station .. PSS 65 C1
Nominal
input voltage .......... 220 - 240 V~, 50 Hz
Power consumption P ..... 65 W (S6 20%)*
Power consumption P
Measurement idling speed n
Safety class .....................................
Protection category..........................IP X0
Weight
(incl. accessories) ........... approx. 1.37 kg
Grinding angle range ................15° - 50°
Sharpness drill diameter ............ 3 -10 mm
Sharpness knife width .............. 6 - 51 mm
Grinding wheel
Outer diameter .................. Ø 49.5 mm
Borehole diameter ............ Ø 10.14 mm
Thickness ................................ 7.9 mm
Abrasive ............................... Diamond
Base body .................................. Metal
Working speed ................ max. 60 m/s
Rotational speed ....... max. 23100 min
Sound pressure level
(L
) ................... 60.5 dB(A); K
pA
Sound power level
(L
) ................. 73.5 dB(A); K
WA
* Operating mode S6 20%: Continuous op-
eration with intermittent load (cycle time
10 min). In order not to heat the motor
more than permitted, the motor may only be
operated for 20% of the cycle time with the
stated nominal power and must then continue
running for 80% of the cycle time without a
load.
** Operating mode S1: Continuous operation
with constant load
GB
MT
..........25 W (S1)**
0
... 6700 min
0
= 3 dB
pA
= 3 dB
WA
-1
II
-1
51
Publicidad
