Publicidad
Idiomas disponibles
Idiomas disponibles
Attach the Rear Fender & Rear wheels
1. The rear wheel fender is clamped in the body of the corresponding clamping slot,
then the body is reversed, screws are installed in the corresponding screw holes and
tightened. (The rear guard plate has 7 screws on the left and 7 screws on the right,
total 14 screws).
Rear Bottom View
1. First slide the motor to the rear axle, and then slide
the rear wheel to the back of the motor. Make sure
the rear wheels match the gearbox on the body
2. Slide a #12 washer onto the rear axle.
3. Tighten a M10 nut to the end of the rear axle.
4. Inset the rear wheel hubcap to the rear wheel.
Repeat steps 1-4 for the other rear wheel.
14
Use a screwdriver to press
the shock absorbers down
into the rear axle as shown
Attach Front Steering Bracket & Front Fender
2. Insert the steering bracket
into the body as shown.
1. Put the iron parts and the #20
washers into the steering bracket.
3. The steering bracket is fixedly by a
Split Pin.
4. The body turning sleeve is provided
with a mud plate steering fixing part.
5. Use #8 washer and M8 nut to tighten.
15
Publicidad
