Home Decorators Collection BRAISE 56045 Guía De Uso Y Mantenimiento página 9

Assembly - Hanging the Fan (continued)
3
Setting the code on the remote
control and receiver
NOTE: The remote control has already been paired to the
ceiling fan for your convenience. If you have two of the same
model fans in your home, please follow the steps below to
control each fan independently.
NOTE: The remote control battery will weaken with age and
should be replaced before leaking takes place, as this will
damage the remote control. Dispose of used battery properly
and keep the battery out of the reach of children.
□
Confirm that the power to the fan is off at either the wall switch
or breaker box.
□
Remove the battery cover by pressing firmly on the arrow and
sliding the cover off.
□
Install the 23A battery (P).
□
Return power to the fan at the wall switch or breaker box.
□
Press and release the "Learn" button for 1-2 seconds, located in
the remote's battery compartment within 30 seconds of turning
on the power.
□
If pairing is successful, the fan's light kit will flash and the
blades will begin to spin.
□
Replace the battery cover on the remote control.
1 to 3 mode
□
To use more than one remote control for your fan, press the
"Learn" button for 10 seconds and release within 30 seconds of
turning on the power. Once pairing is successful, the fan's light
kit will flash and the blades will begin to spin.
□
Repeat the above process for the remote controls you want to
work with this fan.
□
The fan can be only controlled by 3 remote controls maximum
at the same time after "Learning". If you use a forth remote
control to handle the fan, the first remote control will be
replaced.
1 to 1 mode
□
To use only one remote control for your fan, press and release
the "Learn" button for 1-2 seconds within 30 seconds of turning
on the power. The "1 to 3" mode will be cleared and returned
back to "1 to 1" mode.
4
Installing the receiver
WARNING: To reduce the risk of fire or electric shock,
remember to disconnect power. The electrical wiring must
meet all local and national electrical code requirements.
The electrical source and fan must be 110/120 volt, 60Hz.
Do not use this product in conjunction with any variable wall
control. Incorrect wire connection can damage this receiver.
CAUTION: If other fan wires are a different color, have this
unit installed by a licensed electrician.
□
Position the house supply wires (AAA) to one side of the
slide-on mounting bracket (A). Position the fan wires (BBB)
to the opposite side.
□
Insert the narrow end of the receiver (L) (as shown, flat side
towards the ceiling) into the slide-on mounting bracket (A)
until it rests on top of the ball/downrod assembly (B).
A
AAA
9
Please contact 1-800-986-3460 for further assistance.
L
L
HOMEDEPOT.COM/HOMEDECORATORS
BBB
B
C