Pekatherm O120D Manual De Instrucciones página 12

3) Proceed to adjust the temperature among the four available settings by pushing the
button on the control unit. The LED indicator corresponding to the temperature setting
you have selected will remain lit. At this point the product is running normally. After a few
minutes you will be able to perceive warmth.
4) To switch off the product proceed to push the button until all the LED indicators are off
(level 0). The heating element remains switched off in this position. To turn the product on
push the button. Remember to unplug the product from the mains if you do not use it for a
considerable period of time.
5) Unplug the product and let it cool down before folding it for storage.
To maximize safety when using the product, an additional safety switch off function has
been incorporated into every control unit. This function sets a maximum period of time
for which the product can operate continuously. The period is set for 12 hours for heating
overblankets. When this period has elapsed, the product will switch off automatically. This
reduces the risk to the user of spending too much time in contact with the heating element,
as well as the risk of leaving the product in operation unnecessarily. When the safety AUTO-
OFF function is activated, the heating element is switched off and the LED indicators of the
controller go off. To restart the product push the control unit button.
Excessive heat continuously applied to the skin may produce skin burns. The maximum
temperatures our products can ever reach are those permitted by the current regulations.
The heating overblankets reach temperatures between 45ºC and 55ºC.
(Note: all measures were collected in laboratory conditions with products totally covered,
according to procedures described in the EN60335-2-17 Standard).
It usually takes 45 to 60 minutes for the product to reach the maximum temperature.
You can set the control unit at the maximum level to obtain a faster warm up. Remember,
however, that you should not use this setting continuously for more than one hour. After
that time, we recommend that you lower the temperature gradually.
For overnight or continuous use we recommend setting the unit at its lowest level (level 1).
Benefits provided by these products have little to do with high temperatures and are based
on a consistent, controlled low-level heat.
This product family is specially designed to ensure a smooth low-level heat which, apart
from comfort, provides recognised pain relieving effects, since it dilates the blood vessels
and enables muscular distension.
The control unit was designed and developed together with the heating elements to assure
the best performance.
INSTRUCTIONS
SafETY aUTO-Off
aDvICE ON TEmPERaTURE SElECTION
TEChNOlOGY
12