Home Decorators Collection MLWWVT2416 Guía De Uso Y Mantenimiento página 4

Assembly
1
Attaching the legs
□ Carefully tip the vanity (A) backward to expose the drill
holes on the underside near the front.
□
Set the leg (C) against the vanity (A), aligning the drill
holes with those in the angled piece. Thread 2 washers
(AA) and 2 metal rings (BB) onto each screw (CC). Thread
through each drill hole and into the leg (C). Tighten with
the hex wrench (DD) until the foot (C) is tight against the
vanity (A).
□
Repeat with the other front leg (C), then with the two back
legs (C).
2
Installing the top
CAUTION: Two people are needed to safely lift the top
and accurately position it onto the vanity.
□ Wipe off the top edges of the vanity (A) that will be in
contact with the top using a clean rag.
□
Apply a layer of silicone along all of the top edges.
□
Align the top (B) with the vanity (A).
□
Slowly lower the top (B) onto the vanity (A).
AA
BB
CC
DD
C
4
A
B
A