Publicidad
Idiomas disponibles
Idiomas disponibles
c. Push the pressure connector into the
open end of the of hot water flex tubing
with the washer facing out.
Step 4c
IMPORTANT: Be sure to slide the hot
water flex tubing over the pressure
connector until the tubing slides past
the "lip" of the pressure connector and it
cannot go any further.
d. Hold the pressure connector up
against the hot water inlet on the bidet
attachment. Slide the pressure cap
along the tubing and screw the cap onto
the hot water inlet until the pressure
connector is secure.
Step 4d
5. Turn on water supply and check for leaks
a. Open the main water supply valve slowly
and check for leaks.
b. Wait 5-10 minutes, check again, and if
there are no leaks, continue.
NOTE: If there is any leaking, check all
rubber washers and make sure all water
connections are tight and secure. If
necessary, you can use plumber's tape
for any leaking connections.
11
Publicidad
