Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Before Installation
IMPORTANT:
Please be advised that the provided cold
water T-Valve should be installed at the fill
valve under the toilet tank. Do not disconnect
from water supply valve on the wall.
NOTE: The hot water T-Valve will be
installed at the hot water supply under
your bathroom sink. If you do not have
access to the fill valve under the toilet
tank, visit us at www.brondell.com or
contact us at 1-888-542-3355 for further
assistance.
For FSA-25 Dual Temperature Model Only
Check the size of the hot water supply
connection (most likely under the sink/
washbasin). This should be a ⅜" connection to
properly fit and install the enclosed T-Valve.
NOTE: If the connection is a ½"
connection, you will need to purchase
the following reducing adapter available
online and at many plumbing hardware
stores: Reducing Adapter, ½" Female
NPT x ⅜" Male Compression
Check water supply line
Check the water supply line that connects the
toilet tank fill valve to the water shut-off valve
at the wall.
• If it is a rigid pipe, you will need to purchase
a flexible water supply hose to replace it
before installing the FreshSpa.
• The length of the hose may vary, and the
top connection size should be ⅞" ballcock
to connect to the T-Valve that you will install
under the toilet tank.
• The bottom connection will vary
(most common are ⅜" and ½" female
compression).
6
Publicidad
