Sinbo SSI 2876 Instrucción Del Uso página 12

• position for nylon and acetate
• • position for wool ,silk or mixures
• • • position for cotton or linen (steam).
How to fill the water tank
1. Unplug the iron.
2. Set the steam ruler to dry ironing.
3. Fill the tank through the filling hole.
4. If you have hard water, it is advisable to use only distilled or demineralized water.
- do not use chemically de-limed water or perfumed
5. Do not store the iron with water in the tank.
Steam ironing
1. Fill the iron as described in the section "how to fill the water tank".
2. Plug the iron into the mains.
3. Steam ironing is only possible when the highest temperatures shown on the temperature
control are selected.
Otherwise, water may escape through the soleplate.
4. Wait until the pilot light goes out, which indicates that the selected temperature has been
reached.
5. Turn the steam button to the required position.
6. When the ironing is finished and during breaks in ironing place the iron in its upright position.
7. Disconnect the iron from the mains supply. Pour of any remaining water and leave the iron
to cool off.
Spray
1. The spray can be used in any position, either in dry or steam ironing, as long as the water
tank is filled with water.
2. Press the spray button for this function
NOTE: This button has to be pressed repetitively to start this function for the first time.
Shot of steam
Shot of steam give extra steam for removing persistent wrinkles.
1. Place the temperature selector at the "max"position and wait until the pilot light goes out
2. Wait for a few seconds for the steam to penetrate the fibre before pressing again.
NOTE: For the best steam quality, do not use more than three successive bursts each time.
Several pumping actions are needed to start this function.
Excessive use of this feature will cause the iron to cool, ensure that the pilot light is out, before
operating the shot of steam control
Cleaning
1. Disconnect the appliance from the mains, before cleaning.
2. Do not use solvents or abrasive products to clean the iron, clean with a damp cloth.
Defects and repairs
Do not attempt to replace a defective mains lead. The appliance has to be returned to an
authorized service centre for repair.
- 11 -