Selco WU 230 Instrucciones De Uso página 12

1.5 IP Protection rating
S
IP23S
- Enclosure protected against access to dangerous parts by fin-
gers and against ingress of solid foreign bodies with diameter
greater than/equal to 12.5 mm
- Enclosure protected against rain at an angle of 60°.
- Enclosure protected against harmful effects due to the ingress
of water when the moving parts of the equipment are not
operating.
1.6 Cooling liquid
1.6.1 Personal protection
Product harmful if swallowed. Can cause irritation
to eyes, mucous membranes and skin.
Use rubber gloves to prevent contact.
Use safety goggles to prevent accidental splashes.
Wear ordinary work clothes to prevent contact with
the skin.
1.6.2 Disposal
Any leaks or remains of product, after it has been
used, must be treated in a suitable purification plant
or recycled if possible. Do not discharge the used
product into watercourses, ditches or drainage sys-
tems. The diluted fluid should not be discharged into
the sewers unless permitted by the local regulations.
2 INSTALLATION
Installation should be performed only by expert
personnel authorised by the manufacturer.
During installation, ensure that the power source is
disconnected from the mains.
12
2.1 Lifting, transport and unloading
procedures
- The system is not equipped with specific lifting gear.
Do not underestimate the weight of the equip-
ment: see technical specifications.
Do not move or position the suspended load
above persons or things.
Do not drop or apply undue pressure on the
equipment.
2.2 Positioning of the equipment
Keep to the following rules:
- Provide easy access to the equipment controls and connec-
tions.
- Do not position the equipment in very small spaces.
- Do not place the equipment on surfaces with inclination
exceeding 10° from to the horizontal plane.
- Position the equipment in a dry, clean and suitably ventilated
place.
- Protect the equipment against pouring rain and sun.
2.3 Connection
The cooling unit is provided with a connector 1 for connection
to the power source.
The cooling unit is provided with a connector 2 for connection
to the power source.