Bresser TemeoTrend SQ Instrucciones De Uso página 20

mode to skip to the next input field. Press and
hold down the button for about 2 seconds in the
setting mode to save the settings and exit the
setting mode.
CH/+ button (Fig. 1, 3)
Press the button in display mode to choose
channel 1, 2 or 3 of an outdoor sensor. Press
and hold down the button for about 2 seconds to
activate the automatic channel-change indicator.
Press the button again to return to the normal
display mode. Press the button in the setting
mode to increase the value of a flashing field.
MEM/- key (Fig. 1, 4)
Press the button to display the max/min values
for the indoor and outdoor temperature, for
about 5 seconds. Press and hold down the
button for about 2 seconds in max/min mode
to clear the max/min values. Press the button
in the setting mode to reduce the value of a
flashing field.
°C/°F switch (Fig. 1, 6)
Move the switch to position °C or °F to switch
between temperature display in °C or °F.
20
SENSOR button (Fig. 1, 7)
Press the button to perform the channel test for
the weather station and outdoor sensor.
RCC button (Fig. 1, 8)
Press and hold down the button for about 8
seconds, to activate or deactivate the auto
receive operation of the time signal.
RESET button (Fig. 1, 9)
Press the button with a thin metal rod in the
event of a malfunction for resetting the device
settings.
Outdoor sensors (Fig. 2/ Fig. 3)
LED-operation display
(Fig. 2, 10/ Fig. 3, 15)
Flashes when transmitting information at the
weather station.
Switch for channel selection
(Fig. 2, 14/ Fig. 3, 19)
Slide the switch to position 1, 2 or 3.