Turn On/Off The Unit; Mute; Faceplate Release; Sound Adjustment - Blaupunkt MADRID 170 BT Manual De Instrucciones

OPERATION

TURN ON/OFF THE UNIT

Turn on the unit by pressing
When system is on. Press and hold
button (4) for 2 seconds to turn off the unit.

MUTE

Shortly press MUTE button(1) to muting
the audio output. Press it again to recover
output.

FACEPLATE RELEASE

Press release button
removable faceplate.

SOUND ADJUSTMENT

Press MENU button (4) shortly to select the
desired adjustment mode. The adjustment
mode will change in the following order:
-BASS-TRE-BAL-FAD-EQ-XBASS-BEEP-
DX-STEREO-CLOCK-AREA
TRE: treble
BAL: balance
FAD: fader
equalization
EQ:
distance
DX:
By rotating the audio knob (19) it is possible
to adjust the desired sound quality or
setting.
Press and hold MENU button (4) for 2 seconds
into the RDS menu as below:
AF-TA-TA VOL-REG-EON
AF: Alternative Frequencies
TA: Traffic Announcement
TA VOL：TA volume
EON: Enhanced Other Network
EQ (Equalisation)
Press it shortly to select the preset EQ mode
as below:
CLASSICS—ROCK—POP—FLAT—EQ OFF
XBASS
Press and hold the EQ button for 2 seconds
to active the XBASS function. Press and hold
it again to cancel this function.
button(4).
(5) to detach the
5

BEEP on/off:

The car audio device is equipped with 2
beep tone modes. Rotate the volume
knob to choose one.
- Beep on mode: The confirmation beep
sound is heard whenever a button is
pressed.
- Beep off mode: The confirmation
beep is switched off whenever a key
is pressed.
LOC/DX:
In this item rotating the audio knob (6)
to turn on/off local function. In LOC mode
the unit will reduce the receiving
sensitivity when you search station.
That means you can receive the
station that sound is good. It will
ignores the station that sound is not
good. In DX mode it will increase the
receiving sensitivity when you search
the station. That means you can
receive more stations.
STEREO/MONO: In this item rotating the
audio knob (6) to choose STEREO or MONO
mode. In STEREO mode you can receive FM
stereo signal. In MONO mode the stereo
station will be switched to monochrome.
Sometimes when the signal is not good. If
you change it to MONO mode. The noise
will be reduced.
CLOCK
In the CLOCK item of the SEL menu. There are
12 HOUR and 24 HOUR format for your choose.
Note: If you select the EUR(USA or LAT) region
in AREA item. The clock will become to 24(12)
HOUR format automatically. If you want to use
12(24) HOUR format in EUR(USA or LAT) region.
You have to setting the clock format again.
AREA:
In the AREA item of the menu. There are
EUR/USA/LAT for your selecting..
E
N
L
I
S
H