Publicidad
Idiomas disponibles
Idiomas disponibles
English
1. Remove the high-pressure hose
storage channel.
2. Attach a nozzle as described in the Fitting the
Accessories section. Attach the chuck to the tire stem
to inflate a tire, or attach an accessory to inflate a ball or
other inflatable.
3. Attach or insert the nozzle into the object being inflated.
4. Press the power switch
2
High-Pressure inflation mode.
nOTE: The pressure gauge display
inflation pressures when the inflator is in high-
pressure mode.
nOTE: To switch between pressure units, press and hold
the inflation mode switch
while rotating the pressure adjustment knob
5. Rotate the pressure adjustment knob
desired pressure.
6. Press the inflation start/pause button
begin inflation.
7. To stop the inflator at any time, press the inflation start/
pause button
7
.
8. When the item to be inflated has reached the preset
value, the unit will automatically turn off.
nOTE: You may notice the actual pressure reading may
drop after a couple of seconds. This is normal.
nOTE: If the power switch
2
be lost and will need to be reentered. This is a safety feature
to prevent the risk of items OVER INFLATING.
Using the Inflator as a Pressure Gauge
1. Connect the high-pressure hose
be checked.
2. Press the power switch
2
3. The pressure gauge display
item's pressure.
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off, remove the battery pack
and disconnect it from the power source before
making any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
Storage Recommendations
Store the inflator indoors. The best storage place is one that
is cool and dry, away from direct sunlight and excess heat
or cold.
Lubrication
This unit requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.
10
10
from its
. The inflator will default to
9
will only show
3
and the LED light switch
4
6
.
6
to set the
to
7
is turned off, all settings will
10
to the item to
.
9
will display the
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Accessories
WARNING: Since accessories, other than those
offered by D
WALT, have not been tested with this
e
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact D
Tool Co., 701 East Joppa Road, Towson, MD 21286, call
1-800-4-D
WALT (1-800-433-9258) or visit our website:
e
www.dewalt.com.
Repairs
The charger, battery pack and external power supply are
not serviceable. If the inflator will not turn on, check the
battery, all connections, and the fuse in the 12V DC vehicle
connector
19
. The inflator display will show an error code
under certain conditions. Refer to the Troubleshooting
Error Codes chart.
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement, when
applicable) should be performed by a D
service center or a D
WALT authorized service center.
e
Always use identical replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
•
WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
•
COnFiRMATiOn OF OWnERshiP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
FOR YOUR sAFETY: Registering your product will
•
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
Register online at www.dewalt.com/register.
Three Year Limited Warranty
D
WALT will repair, without charge, any defects due to
e
faulty materials or workmanship for three years from
the date of purchase. This warranty does not cover part
failure due to normal wear or tool abuse. For further detail
of warranty coverage and warranty repair information,
visit www.dewalt.com or call 1-800-4-D
WALT
e
WALT Industrial
e
WALT factory
e
WALT (1-800-
e
Publicidad
