Publicidad
Idiomas disponibles
Idiomas disponibles
When working on air tools, note the warnings in this manual and use extra care
evaluating problem tools.
CAUTION: Pusher spring (constant force spring). Caution must be used when working with the spring
assembly. The spring is wrapped around, but not attached to, a roller. If the spring is extended beyond
its length, the end will come off the roller and the spring will roll up with a snap, with a chance of
pinching your hand. Also the edges of the spring are very thin and could cut. Care must also be taken
to insure no permanent kinks are put in the spring as this will reduce the springs force.
REPLACEMENT PARTS:
BOSTITCH replacement parts are recommended. Do not use modified parts or parts which will not give
equivalent performance to the original equipment.
AIR SUPPLY-PRESSURE AND VOLUME:
Air volume is as important as air pressure. The air volume supplied to the tool may be inadequate because
of undersize fittings and hoses, or from the effects of dirt and water in the system. Restricted air flow will
prevent the tool from receiving an adequate volume of air, even though the pressure reading is high. The
results will be slow operation, misfeeds or reduced driving power. Before evaluating tool problems for these
symptoms, trace the air supply from the tool to the supply source for restrictive connectors, swivel fittings,
low points containing water and anything else that would prevent full volume flow of air to the tool.
N80K2
Remote Cycle Kit
121165
Assembly N62 Magazine
CNTK1
Kit. Contact trip conversion (Black trigger)
TVA11
Trigger valve kit
IMPORTANT NOTE:
treated after nails are manufactured. As such, we do not guarantee or warranty product
against corrosion for any specified time.
MAINTAINING THE PNEUMATIC TOOL
Steel finish nails are made from galvanized steel wire and not
-11-
ACCESSORIES AVAILABLE:
Publicidad
