Publicidad
Idiomas disponibles
Idiomas disponibles
Always disconnect air supply: 1. Before making adjustments; 2. When
servicing the tool; 3. When clearing a jam; 4. When tool is not in use; 5.
When moving to a different work area, as accidental actuation may occur,
possibly causing injury.
"DIAL-A-DEPTH
TRIP ADJUSTMENT
NUT
Models N52FN and N62FN, contain a Jam Release feature.
ALWAYS DISCONNECT AIR SUPPLY BEFORE CLEARING A JAMMED FASTENER.
2
Jam Clearing
Disconnect air supply from tool.
Relieve fasteners from pusher.
1: Depress latch button
2: With the latch button depressed, rotate latch
assembly upward & forward until latch is on
upward position
Full Release Of Magazine
5: Pull latch upward
6: Rotate latch assembly to forward direction
™
" FASTENER CONTROL ADJUSTMENT
Shallow
Deep
1
6
5
The DIAL-A-DEPTH
feature provides close control of the fastener drive
depth; from flush with the work surface to shallow or
deep countersink. First, set the air pressure for
consistent drive in the specific work as described on
page 4, then use the DIAL-A-DEPTH
Control adjustment to give the desired depth of
drive.
Partial Release Of Magazine
3: Slide magazine to rear of tool
4: Clear Jam
Magazine Assembly Removal
7: Slide the magazine assembly to the rear of tool to
disengage. To re-assemble the magazine assembly
back on the tool. Reverse the procedures and re-
engage the latch to lock the magazine assembly in place
-9-
Fastener Control adjustment
™
Fastener
™
JAM RELEASE
3
4
Publicidad
