Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
Stops.
Fills with the wrong
temperature water.
Door (Lid) locked or will
not open.
54
English
Untitled-1 54
Untitled-1 54
• Make sure the washer's power cord is fully plugged in and
the circuit is live.
• Check the fuse or reset the circuit breaker.
• Close the door, and then press or tap START/PAUSE to
start the washing machine. For your safety, the washing
machine will not spin unless the door is closed.
• Before the washing machine starts to fill, it will make a
series of clicking noises to check the door lock, and then
does a quick drain.
• There may be a pause or soak period in the cycle. Wait
briefly and the washing machine may start.
• Make sure the inlet hose filters at the taps are not clogged.
Periodically clean the filters. See page 50.
• This problem can occur temporarily due to low voltage in
your household electrical system. It will be resolved when
the voltage returns to normal.
• Fully open both water taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct water
taps. Flush the water lines.
• Disconnect the hoses and clean the mesh filters. The water
inlet mesh filters may be clogged. See page 49.
• While the washing machine fills, the water temperature
may change as the automatic temperature control feature
checks incoming water temperature. This is normal.
• While the washing machine fills, you may notice just hot
and/or just cold water going through the dispenser when
cold or warm temperatures are selected. This is a normal
function of the automatic temperature control feature as
the washing machine determines the water temperature.
• While the washing machine is operating, press or tap
START/PAUSE to stop the washing machine.
• It may take a few moments for the door lock mechanism to
disengage.
Action
2023-03-31( )
2023-03-31( )
11:06:38
11:06:38
Publicidad
