ADURO 22 Serie Manual De Usuario página 33

2.3 Connection to a brick chimney
If the stove is being connected to a brick chimney you should use the rear outlet or a curved flue pipe via the
top outlet. After measuring, a hole is made in the chimney in which the pipe sleeve is placed, and stove
mortar is used to seal it in place. The stove is placed in position, and the flue pipe is put in place. A thin
gasket is placed between the flue pipe and the pipe sleeve to seal the joints. The flue pipe should protrude
into the pipe sleeve but must not block the opening in the chimney (see the illustration below). You may
benefit from putting a slim gasket between the flue on the stove and the flue pipe.
The stove can be connected to a chimney to which other heat sources are connected.
Applies to Aduro 22.4 Lux:
Aduro 22.4 Lux must be mounted onto brick chimneys including insulated chimney elements. The stove
cannot be mounted directly to a brick chimney without insulated chimney elements or directly onto insulated
chimney elements as shown below:
2.4 Attachment / hanging of Aduro 22.4 Lux
Aduro 22.4 Lux must be installed on a non-flammable wall. The stove is being delivered with wall fittings
which must be properly fastened to the wall before mounting the stove (instructions are enclosed with the
stove). You may consult your normal supplier of building materials about suitable attachment materials for
the stove/wall before the mounting. ONLY USE FIXING MATERIALS WHICH CANNOT MELT. If you have
any doubts about the requirements, please consult your chimney sweep who will inspect the stove.
33