Genesis GDP805P Manual Del Operario página 9

ADJUSTING TABLE BEVEL (FIG 8)
The table can be tilted 0° to 45° to the left and right.
1. Loosen the bevel lock bolt (D3) with a wrench.
2. Tilt the table (7) to the desired angle, using the bevel scale (16)
as a basic guide.
3. Re-tighten the bevel lock bolt (D3).
4. To return the table to its original position, loosen the bevel lock
bolt. Realign the bevel scale to the 0° setting.
5. Tighten the bevel lock bolt with the wrench.
SETTING DRILL DEPTH (FIG 9)
Drill depth scale (15) is on the left side of the drill press head. See
fIG 9. The scale pointer (A1) indicates the spindle travel distance.
To stop the drill at a specific depth for consistent and repetitive
drilling:
1. feed the spindle down to the desired position.
2. While holding it, turn the lower stop nut (A3) on the depth guide
(A5) all the way down to the stop shoulder (A6), then turn the
upper nut (A2) down to lock the lower stop nut on the shoulder.
3. The chuck will stop after traveling downward to the distance
selected.
SQUARING THE TABLE TO THE HEAD
(FIG 10)
1. Install a 3" long drill bit (a) into the chuck (4).
2. Raise and lock the table (7) about 1" from the end of the drill bit.
3. Place a combination square (b) on the table as shown. The drill
bit should be parallel to the straight edge of the square.
4. If an adjustment is needed, loosen the bevel lock bolt (D3-fIG 8)
with a wrench.
5. Square the table to the bit by tilting the table.
6. Tighten the bevel lock bolt when square.
ADJUSTING THE PLAY OF SPINDLE
(FIG 11)
NOTE:
The spindle was properly adjusted at the factory and
should not be readjusted unless necessary.
Move the spindle to the lowest downward position and
hold in place. With your other hand, try to make it
revolve around its axis with a side motion. If there is too
much play proceed as follows:
1. Loosen the lock nut (A4).
2. Turn the screw (A8) clockwise to eliminate the play but without
obstructing the upward and downward motion of the spindle (a
little bit of play is normal).
3. Tighten the lock nut (A4).
FIG 8
7
16
D3
A6
4
a
7
A4
A8
6
8
A1
A2
A3
A5 15
FIG 9
FIG 10
b
FIG 11
9