Asist AE8GD1370 Manual De Instrucciones página 53

Turn the AC switch to „OFF" position to protect your
security personnel, make sure the generator should
be grounded.
Trigger generator
Electric start
Turn the ignition key to the „start" position (no more
than 8
seconds), remove your hand from the key as soon as
the engine starts and let the key automatically return
to the home position. If the starter motor does not
start, please wait about 30 seconds before trying to
start again.
Connection
Connect the AC breaker, the generator will start to
supply power.
Stopping the generator
Caution: Do not stop the generator when it is under
load. it will destroy the generator.
Before turning off the generator, turn off and disco-
nnect all electrics. appliances from the generator.
Before switching off, let the generator run without load
for a short time to allow the unit to „cool down".
Turn off the AC breaker. Turn off the starter switch -
Turn the key to the „OFF" position.
Appliance connection
Start the engine.
Check that the voltmeter or indicator light shows the
correct voltage.
Before connecting to the generator, turn off the switch
of the electrical appliance (s).
Insert the plug of the electrical appliance (s) into the
socket.
Turn on the electrical appliance.
Electrical equipment (chainsaws, drills, etc.) may
have a higher current consumption (W or A) than
indicated on the nameplate when used under difficult
conditions.
! Do not exceed the specified load limit of
2800W/3000W..
Improper connection between the generator and the
device can damage the device or even cause a fire.
! The generator contains a protective device against
overload.
If the protection device switches off the generator
during operation, reduce the electrical power you take
from the generator.
Use of DC voltage
- The generator is equipped with a 12V DC voltage
output (10), which is used to charge car batteries.
! Do not use the DC voltage output for purposes other
than charging car batteries.
To use this output, connect the end of the included
cables to the DC voltage output (10).
When charging the batteries, follow the instructions
that came with your battery.
CLEANING AND MAINTENANCE
CAUTION: Before performing any maintenance, stop
the engine, allow it to cool, and disconnect the ignition
cable from the spark plug.
-! Do not replace generator parts, perform repairs
yourself, or otherwise interfere with the machine de-
sign. Product repair may only be performed by trained
personnel, resp. authorized service organization.
- Regularly check the generator for damage.
- Regularly remove dust and dirt from the generator
- Store the generator in a dry place and out of reach
of children.
- Never clean any part of the generator with a hard,
sharp or rough object.
- Cleaning is best done with a soft brush or cloth.
- When shutting down for a long time, remove the fuel
from the generator.
Oil change
Open the left door, use a fork to loosen the drain plug
(do not remove the screw), insert the oil guide groove
under the drain screw, let its outlet connect with the
oil container, then completely remove the drain plug.
Then start pulling out the oil, when the oil overflows,
use diesel to clean the inside if necessary
cylinder block. Finally, secure the drain plug back.
53