VMI CUBE Manual página 63

Type of cable: 3 x 1.5 mm² (2-phase + earth conductor)
Network: Single phase, 230 VAC, 50 Hz
Brown
Yellow/Gree
D. Installing the control unit
1.
Use your thumbs to slide the hatch on the back of the
•
control unit open.
Insert the 3 x LR6/AA batteries provided.
•
Close the cover by sliding it in the opposite direction.
•
2.
The control unit must be installed at least 1 m and not more than 30 m away from the
•
VMI unit.
®
Some obstacles may reduce the maximum range of the radio communication (walls,
•
metal objects, floors, etc.).
The control unit must be secured to a horizontal support surface,
•
Preferably close to a heating thermostat if the premises are equipped with one.
•
Do not install the control unit close to a hot or cold source.
•
E. Installing the humidity or indoor air quality sensors (options)
Make sure to refer to the installation instructions provided with the sensor.
n
Blue
Inserting batteries
Location of the control unit
Sealed box
Phase
Ground
Neutral
63