Leggett & Platt 50 II Manual Del Propietário página 10

To tandem sync two bases to operate as one base, perform the followning procedure:
STEP 1
Locate the sync cable (FIGURE 9).
STEP 2
Unplug both remote control cords from respective
base motor cables.
STEP 3
Plug one male end of sync cable into motor cable of
base 1; place the other male end of sync cable into
motor cable of base 2.
STEP 4
Plug (1) remote control cord into female end of sync
cable. Second remote is not needed. Retain for future
use.
One remote control will now operate both bases.
FIGURE 9
SYNC CABLE
FEMALE END
(CONNECTS
TO REMOTE
CONTROL)
MALE END
(CONNECTS
TO BASE 1)
10
TANDEM SYNCING
POWER CORDS MUST NOT INTERFERE WITH
ANY ADJUSTABLE BASE MECHANISMS.
DO NOT WEAVE CORDS THROUGH BASE
MALE END
(CONNECTS
TO BASE 2)
WARNING
!
STRUCTURE.