Leggett & Platt 50 II Manual Del Propietário página 4

To assemble adjustable base, complete the following procedure:
STEP 1
Place adjustable base shipping container on solid,
level surface. Remove top section of shipping
container. Remove packing material. Carefully, lift
adjustable base out of bottom section of shipping
container and place on clean surface. Allow for
enough space to unfold base in setup area.
STEP 2
Raise the top section of the adjustable base and
remove hardware / leg boxes.
STEP 3
Remove captive pin and bolt from hinge (one on each
side) and fold adjustable base out flat (FIGURE 1).
FIGURE 1
BOLT
REMOVE
CAPTIVE PIN
STEP 4
When base is flat, reinsert bolts and captive pins (FIGURE 2).
FIGURE 2
BOLT
REINSERT
CAPTIVE PIN
BASE IN FLAT
POSITION
4
ASSEMBLY
DUE TO RISK OF INJURY, TWO ADULTS
ARE REQUIRED TO HANDLE AND MOVE
KEEP HANDS AND FINGERS CLEAR OF
HINGES DURING UNFOLDING OF BASE.
IMAGES SHOWN MAY DIFFER FROM ACTUAL
WARNING
!
ADJUSTABLE BASE.
WARNING
!
PINCH POINT!
NOTE
PRODUCT.