Leggett & Platt 50 II Manual Del Propietário página 6

STEP 6
Remove remaining packaging. Cut the zip-tie and remove the mattress
retainer.
CAUTION: EXERCISE CAUTION WHEN USING SHARP INSTRUMENTS.
If setting up two twin bases to operate as one king base (tandem setup), refer
to Tandem Syncing section of manual before proceeding.
STEP 7
Plug remote control cord into base motor cable (FIGURE 3). Pivot cable
latch downward and snap cable latch in closed position (FIGURE 4). Note:
Align pins before inserting plugs (FIGURE 4). Do not weave cords through
base structure.
FIGURE 3
STEP 8
Plug electrical power cord into power brick. Plug
brick power cord into base motor cable. Secure
connection using cable latch (FIGURE 5). Note: Align
pins before inserting plugs.
Plug electrical power cord into power outlet.
Note: An electrical surge protection device is
recommended (not included).
6
ASSEMBLY
MOTOR
CABLE
REMOTE
CONTROL
CORD
FIGURE 5
FIGURE 4
LINE UP PINS
ON REMOTE
CONTROL CORD
AND MOTOR
CABLE
WARNING
!
POWER CORDS MUST NOT INTERFERE WITH
ANY ADJUSTABLE BASE MECHANISMS.
DO NOT WEAVE CORDS THROUGH BASE
STRUCTURE.
BASE MOTOR CABLE
BRICK POWER
CORD
POWER BRICK
CABLE
LATCH
ELECTRICAL
POWER CORD