Sanus VisionMount SF203 Manual De Instrucciones página 9

2
Wall Mounting - Wood Stud
For assitance in determining wall plate location, see Height Finder at sanus.com.
2-1
Locate stud
< 16 mm
(5/8 in.)
2-2
Level wall plate [01] and mark hole locations
2-3
Drill pilot holes as illustrated
2-4
Tighten lag bolts [06] only until they are pulled fi rmly against the wall plate [01]
[06]
6901-002128 <00>
All manuals and user guides at all-guides.com
Verify the center of the stud using an awl, a thin nail, or an edge to
edge stud fi nder.
CAUTION:
damage!
Any material covering the wall must not exceed 16 mm (5/8 in.).
Minimum wood stud size: common 2 x 4 in (nominal 1.5 x 3.5 in).
[01]
CAUTION:
the lag bolt. To avoid potential injuries or property damage: pilot
holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5 mm
(7/32 in.) diameter drill bit.
CAUTION:
the lag bolt. To avoid potential injuries or property damage: DO NOT
over-tighten the lag bolts [06].
Fit lag bolt covers [14] over lag bolts [06].
NOTE: The SF213 is shown.
[01]
Avoid potential personal injuries and property
NOTE: The SF213 is shown.
Improper use could reduce the holding power of
75 mm
(3 in.)
Improper use could reduce the holding power of
[14] [06]
13 mm
5.5 mm
(1/2 in.)
(7/32 in.)
9