Dometic GROUP Waeco MagicComfort MSH200 Instrucciones De Montaje Y De Servicio página 19

MagicComfort MSH200
 When connecting to cable 31 (earth), screw the cable
– To the vehicle's earth bolt with a cable lug and a gear disc or
– To the sheet-metal bodywork with a cable lug and a self-tapping
screw.
Ensure that there is a good earth connection.
If you disconnect the negative terminal of the battery, all data stored in the
volatile memories will be lost.
 The following data must be set again, depending on the vehicle equip-
ment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate
operating instructions.
Observe the following installation instructions:
 Secure the parts installed in the vehicle in such a way that they cannot
become loose under any circumstances (sudden braking, accidents) and
cause injuries to the occupants of the vehicle.
 To prevent damage, when drilling ensure that there is sufficient space on
the other side for the drill head to come out (fig. 2, page 3).
 Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
 When testing the voltage in electrical cables, only use a diode test lamp
(fig. 1 8, page 2) or a voltmeter (fig. 1 9, page 2).
Test lamps with an illuminant (fig. 1 12, page 2) take up voltages which
are too high and which can damage the vehicle's electronic system.
 When making electrical connections (fig. 3, page 3), ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection.
 Insulate all connections.
 Secure the cables against mechanical wear with cable binders or insulat-
ing tape, for example to existing cables.
Safety and installation instructions
19