INSTALLATION INSTRUCTIONS
Before Using Your Appliance
Remove the exterior and interior packing.
•
•
Before connecting the appliance to the power source, let it stand upright for approximately 4 hours.
This will reduce the possibility of a malfunction in the cooling system from improper handling during
transportation.
Clean the interior surface with lukewarm water using a soft cloth. (Cleaning instruction on page 7)
•
Installing Your Appliance
• This appliance is designed to be free standing only, and should not be recessed or built-in.
Place your appliance on a floor that is strong enough to support the appliance when it is fully loaded.
•
•
Allow 5 inches of space between the back and sides of the appliance, which allows the proper air
ventilation. Adjust the feet to keep the appliance level.
•
Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption.
Ambient temperature below 55°F will hinder the performance of this appliance. This unit is not
designed for use in a garage or any other outside installation.
•
Avoid locating the appliance in moist areas.
Plug the appliance into dedicated, properly installed-grounded wall outlet. Do not under any
•
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
power and/or grounding should be directed toward a certified electrician or an authorized service
center. This unit is not designed to be installed in an RV or used with an inverter.
After plugging the appliance into a wall outlet, turn the unit on and allow the unit to cool down for
•
2~3 hours under before placing beverages in the appliance .
Electrical Connection
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized service center.
This appliance should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the
possibility of electrical shock.
Do not, under any circumstances, cut or remove the third ground prong from the power cord supplied.
This appliance requires a standard 115V~ / 60Hz electrical outlet with three-prong ground.
This appliance is not designed to be used with an inverter.
The cord should be secured behind the appliance and not left exposed or da ngling to prevent accidental
injury.
Never unplug the ref rigerator by pulling the power cord. Always grip the plug firmly and pull straight out
from the receptacle.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician
negatively affect the performance of the unit.
If any problems with the appliance persist, please contact our Customer Service Dept. to consult with a
representative at 888 775-0202 or visit our website to request warranty service at www.mcappliance.com.
WARNING
install an outlet near the appliance. Use of an extension cord can
4