Member's Mark Enzo SMENZDSK Instrucciones De Montaje página 7

Step 1
H1 x 4
Remove Caps
NOTE: DO NOT fully tighten the nuts until you finish assembling all parts. Once assembled,
go back and fully tighten all the nuts. This will make the assembly easier.
a)
Unpack the units and confirm that you have all hardware and required parts.
b)
Place the Desk Top (A) upside down on a flat and protective surface.
c)
Remove the plastic caps from the hanger bolts on the Left front and back legs (B and C).
d)
Insert the hanger bolts on the Left Front Leg (B) through the drilled holes on the left front corner
block and fit the Hex Nut (H1), Lock Washer (H2) and Flat Washer (H3) onto each hanger bolt.
Securely tighten the nuts with the open wrench provided.
e)
Orient and insert the end wood dowel pre-attached on one Side Stretcher (G) into the hole on
the Left Front Leg (B). Make sure the slant holes will face the floor when the unit is turned
upright.
f)
Repeat the same procedure to attach the Left Back Leg (C) to the left back corner block of
Desk Top (A). Ensure the wood dowel on the Side Stretcher (G) fits into the hole on Left Back
Leg (C) properly.
Need Assistance? Visit us at: samsclub.com/membersmarkhelp
H2 x 4
The slant holes face upward
H3
H2
H1
A
H3 x 4
G
C
B
7 | P a g e