Polar G Serie Manual De Instrucciones página 4

UK
Pack Contents
The following is included:
• POLAR Refrigerator or Freezer
• Instruction manual
• Shelf guides (FA442/FA443)
• Shelves (FA442/FA443 x2)
POLAR prides itself on quality and service, ensuring
that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
Note:
Before using the appliance for
the first time, clean the interior
with soapy water.
The appliance is supplied with
feet by default. However,
castors can be supplied as an
option. Castors can be ordered
using the code of AJ489.
3. Set the brakes on the castors to keep the
appliance in position.
Or,
Level the appliance by adjusting the screw
feet.
4
FA440-FA443_ML_A5_v1_20191202.indb 4
Fitting the Shelves (FA442/FA443)
1. Place one set of shelf guides on either side of
the cabinet at the desired height.
2. Slide the shelf into place.
3. Slide the floor shelf in place.
Operation
Storing Food
To get the best results from your POLAR appliance,
follow these instructions:
• Only store foodstuffs in the appliance when it
has reached the correct operating temperature.
• Do not place uncovered hot food or liquid
inside the appliance.
• Wrap or cover food where possible.
• Do not obstruct the fans inside the appliance.
• Avoid opening the doors for prolonged periods
of time.
Turn On
1. Ensure the power switch is set to [O] and turn
on at the socket.
2. Switch on the Power [I]. The current
temperature within the appliance is displayed.
Control Panel
Set the Operating Temperature
1. Hold the SET button for 3 seconds. The value
of the current set point will be displayed.
2. Press the or buttons to display the
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
• The appliance will automatically run a defrost
cycle every six hours.
• To manually defrost the appliance: Press
and hold the defrost button "aux" for 2
seconds to begin a manual defrost. The defrost
light illuminates.
2019/12/2 10:31