Publicidad
Idiomas disponibles
Idiomas disponibles
Installation and Mounting
CAUTION!
When drilling into any vehicle surface, make sure that the
area is free from any electrical wires, fuel lines, vehicle
upholstery, etc. that could be damaged.
WARNING!
Maximum recommended vehicle speed for safe operation
using the Vacuum Mount model is 65 mph (104 km/h) when
fitted to the center of a vehicle roof of steel construction. Higher
speeds could cause the mount to fail, resulting in the minibar flying
off of the vehicle, which could cause damage to other vehicles and
injury or death to the passengers. The vacuum-magnet mount is
not intended as a permanent mount for the minibar. The vacuum-
magnet mount unit must be mounted on a magnetic surface (i.e. no
fiberglass, etc.). Ensure that the magnet ts kept clean.
NOTE: Operating the vehicle without the outer lens installed
on the product may result in damage that will NOT be
covered under warranty.
Unpacking & Pre-Installation
Carefully remove the microbar and place it on a flat surface. Examine the unit for transit damage, and locate all parts. If damage is found, or
parts are missing, contact the transit company or ECCO. Do not use damaged or broken parts.
Permanent Mounting:
1.
Select the desired location on a flat surface for the microbar to be mounted. The visibility of the flash and ease of wiring access should
be taken into consideration in the selection of the mounting location.
2.
Remove lens screws, then remove lens. Use the four holes in the corners of the base to mark the mounting hole locations.
3.
Drill the holes using a 7/32" drill size.
4.
A fifth hole may be drilled for wire access.
5.
Connect the power wires as shown in the wiring section (see Figures 3 & 4).
6.
(Optional) Place the foam gasket between the microbar and mounting surface.
7.
Mount the microbar with M5 hardware provided.
8.
Replace the lens and fasten with the lens screws.
Vacuum-Magnet Mounting:
The Vacuum-Magnet Mount feature includes a suction cup on the bottom of the microbar, with a magnet inside of the suction cup, for a
secure, temporary mount. The microbar should be placed in the center of the roof where the least amount of curvature occurs. Before install-
ing, make sure the mounting surface is clean and there is no debris on the bottom of the microbar or on the roof of the vehicle, which could
reduce the holding power of the suction cup and magnet. Place and remove the microbar without sliding to avoid scratching the paint on the
vehicle. After placement, the microbar should adhere firmly to the surface. If the unit slides or moves easily, a proper installation has not been
obtained. To release the vacuum, lift the tab to release the airlock (see Figure 1). To protect the Vacuum-Magnet Mount assembly, return
microbar to the box when not in use. Do not attempt to attach the microbar to an ice-covered surface.
PULL/ROLL TAB UPWARD
TO RELEASE VACUUM
Figure 1
IMPORTANT! This unit is a safety device and it must be connected
to its own separate, fused power point to assure its continued
operation should any other electrical accessory fail.
WARNING!
Failure to follow these instructions can result in fire or
injury from excessive heat build up:
• Operator is responsible for ensuring auxiliary plug fits correctly
into auxiliary power plug outlet used.
• For proper operation, verify auxiliary power outlet circuit is rated
to supply a minimum of 10 amps. (See specifications section for
rated current in amperes).
• Do not exceed the current rating for the auxiliary power outlet
recommended by vehicle manufacturer.
• Keep auxiliary plug and outlet clean and free of debris.
• Do not use the auxiliary plug when wet.
• Insert auxiliary plug fully into the outlet for proper connection.
• Grasp auxiliary plug, NOT cord, to remove from outlet.
• Remove auxiliary plug completely from outlet when light is not
in use.
ON - COLOR 2 (DUAL
COLOR ONLY)
OFF
ON - COLOR 1
PATTERN SELECT
Figure 2
Page 2 of 7
Publicidad
