Publicidad
Start Up
Bit and Accessory Installation
• Clean and lubricate lightly the bit and / or accessory
before installing.
• Push the chuck jaw back while inserting the bit and /
or accessory until stopping.
• Release the chuck jaw to set it in the original position. This procedure
will secure the bit and / or accessory. If the chuck jaw is not back to the
original position repeat the former step.
• Try to release the bit and / or accessory from the SDS chuck to double
check the bit and / or accessory are perfectly secured. A perfectly secured
bit and / or accessory cannot be removed unless the chuck jaw slides
back simultaneously.
Do not try to install or remove bits and / or accessories unless the tool is disconnected.
WARNING
Turning ON and Operation Control
• Operation:
Connect the plug into the power supply and the LED indicator will light up
confirming the tool is energized.
Press the trigger switch (A) to start the hammer Drill.
To stop the use, just release the switch.
• High speed is recommended for impact drilling and chiseling works on stone or
concrete.
• Medium speed is recommended to drill on metal.
• Low speed is recommended to start orifices, to prevent the bit from
sliding and chipping the orifice. Such is the case with tiles.
Changing the Operation Mode
• Turn both function selectors (C) and turn the function selector (B)
into one of the 4 positions depending what is the job to carry out.
Listen to a click to make sure the selector is correctly set.
Never change the position in the function
WARNING
selectors when the hammer drill motor is running.
Drill
Hammer Drill
Chisel + Free mode adjustable angle
can turn the chisel in any position
Bit with
SDS-PLUS Shank
1
Chuck
Jaw
2
A
Energy
Indicator LED
Chiseling
ENGLISH
B
C
7
Publicidad
