Publicidad
Idiomas disponibles
Idiomas disponibles
■
Always purchase the correct cell or battery for
an appliance .
■
Keep cells and batteries clean and dry .
■
If the terminals of the cells or batteries are
contaminated, clean them with a dry, clean
cloth .
■
Store the original instructions and information
about the products safely for future information
and reference purposes .
■
Cells and batteries may not be used in applica-
tions for which they are not designed .
■
Always remove batteries from appliances that
are not in use, if possible .
■
Do attempt to recharge non-rechargeable
batteries .
There is a risk of explosion!
Original accessories/auxiliary
equipment
■
Use only the accessories and auxiliary equip-
ment that are specified in the operating instruc-
tions and are compatible with the appliance .
Operation
Changing/inserting the tool/collet
chuck
♦
Press the spindle lock
♦
Turn the tensioning nut
into place .
♦
Undo the tensioning nut
using the combination spanner
♦
Remove any attached tool .
♦
First push the intended tool through the
tensioning nut
before inserting it into the
appropriate collet chuck
shaft .
♦
Press the spindle lock
♦
Push the collet chuck
and screw the tensioning nut
combination spanner
PFBS 160 B2
and hold it down .
until the lock clicks
from the thread
.
for the tool
and hold it down .
into the thread insert
tight with the
.
Using an accessory tool with a mandrel
♦
Use the screwdriver side of the combination
spanner
to undo and tighten the screw on
the mandrels
or
♦
Insert the respective mandrel
the appliance as described .
♦
Use the combination spanner
screw on the mandrel
♦
Insert the desired accessory tool between the
two washers on the screw .
♦
Use the combination spanner
screw on the mandrel
Whet stone
♦
Do not manually grind any edges with the whet
stone
.
Fitting abrasive belts
♦
Push the abrasive belt
mandrel
. Tighten the screw on the abrasive
belt mandrel
in order to fix the abrasive belt
.
Fitting polishing attachments
♦
Screw the polishing attachment
of the mandrel for polishing attachments
Switching on and off/setting speed
range
CAUTION!
■
The rotation direction can be read off the
arrow engraved on the union nut
clockwise symbol) .
Switching on/setting the speed range
♦
Set the ON/OFF switch
♦
Set the infinitely variable speed control
a position between "1" and "MAX" .
Switching off
♦
Move the ON/OFF switch
"O" .
.
,
or
into
to undo the
or
.
to tighten the
or
.
onto the abrasive belt
onto the tip
.
(anti-
to the "I" position .
to
to the position
GB │ MT
│
63
■
Publicidad
