Descargar Imprimir esta página

GreenWorks Pro LMB408 Manual Del Operador página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

11.4
STAND THE MACHINE ON END
1. Remove the grass catcher.
2. Pull and turn the handle knobs (13) 90°.
3. Fold down the handle.
4. Turn the handle knobs 90° to lock the handle into
position.
5. Stand the machine on end and make sure that the brackets
touch the floor.
Storage Switch
The machine has a storage switch (22) that prevents its
startup in the storage position.
It is necessary to remove the safety key and the battery pack
to prevent accidental startup or unapproved use. The storage
switch does not replace this function.
12
TROUBLESHOOTING
Problem
Possible cause
The handle is not
The bolts are not
in position.
engaged correctly.
The machine does
The battery ca-
not start.
pacity is low.
The bail switch is
defective.
The safety key is
not put in.
English
Problem
The machine cuts
grass unevenly.
The machine does
not mulch correct-
ly.
The machine is
hard to push.
There is a high vi-
bration in the ma-
chine.
The machine stops
during mowing.
Solution
Adjust the height
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
Charge the battery
* If you cannot find the solution to these problems, go to the
pack.
service center.
Replace the bail
13
switch.
Put in the safety
Voltage
key.
Battery model
Charger model
13
Possible cause
The lawn is rough. Examine the mow-
The blade height is
not set correctly.
Wet grass clip-
pings attach to the
deck.
The mulch plug is
missing.
The grass is too
tall, or the blade
height is too low.
The grass catcher
and the blade
drags in thick
grass.
The blade is un-
balanced and
worn.
The motor shaft is
bent.
The blade height is
too low.
The battery pack is
out of power.
The grass clip-
pings attach to the
deck or the blade.
Operation temper-
ature of the ma-
chine is too high.
TECHNICAL DATA
80 V
BAB729 and other BAB series
2901402 and other CAB series
EN
Solution
ing area.
Adjust the blade/
cutting height to a
higher position.
Wait until the
grass dries before
mowing.
Install the mulch
plug.
Increase the blade/
cutting height.
Empty the grass
clippings from the
grass catcher.
Replace the blade.
1. Stop the mo-
tor.
2. Remove the
safety key and
battery pack.
3. Inspect for
damage.
4. Repair the ma-
chine before
you start it
again.
Increase the blade/
cutting height.
Charge the battery
pack.
Remove the bat-
tery pack and
check the deck.
Cool the machine.

Publicidad

loading