El-Skyport Modules; Troubleshooting - Elinchrom BRX 250 Manual De Funcionamiento

EL-Skyport Modules

EL-Skyport Universal SPEED (NEW) / Universal (previous version)
• Universal Receiver for all makes of Flash with a SYNC socket, conforming to Sync norms!
EL-Skyport Transceiver RX
• This Transceiver is only for Elinchrom RX units. The module operates all RX
features with the EL-Skyport software and triggers the flash.
EL-Skyport USB RX SPEED (NEW) / USB RX (previous version)
• To operate RX flash units via computer the USB module should be used in
conjunction with the EL-Skyport Transceiver RX and the EL-Skyport software.
Universal Speed
& Universal

Troubleshooting

Should an error occur, first check the following points:
Having this problem?
No flash unit can be triggered
with the Transmitter
Mode "All" is selected
Some units do not fire when
triggered with the Transmitter
Mode "Grp" is selected
TEST flash works, but the camera
will not trigger flash unit
Limited Distance range
Transceiver RX
19353
Check the following points:
 Check if the Transmitter is switched ON.
 Check battery polarity.
 Check if the Receiver module is connected correctly to the unit.
 Check if the frequency selector switch is set to the same channel.
 Check if Transmitter is in the same trigger mode Speed or Standard.
 Check if the Channel selector switch is set to the same Group.
 Reduce distance to any "not working" unit.
 Check if Transmitter is in the same trigger mode Speed / Standard.
 Check hot-shoe fitting.
 Connect the 2.5 mm to PC SYNC cable instead of hot-shoe connection.
 Reposition the units.
 Increase the distance to walls and ceilings.
 Position the antenna of Transmitter and Receiver.
 Use an RX extension cable to reduce the distance between the modules.
English
USB RX Speed
& USB RX
21