Publicidad
Idiomas disponibles
Idiomas disponibles
injury at the rate for which it was designed.
13)Don't Overreach - Keep proper footing
and balance at all times.
14)Stay Alert - Watch what you are doing.
Use common sense. Do not operate
appliance when you are tired.
15)Disconnect Appliance - Disconnect the
appliance from the power supply when not
in use, before servicing, when changing
accessories such as blades, and the like.
16)Store Idle Appliances Indoors - When
not in use, appliances should be stored
indoors in dry, and high or locked-up place
- out of reach of children.
17)Maintain Appliance With Care
- Follow instructions for changing
accessories. Inspect appliance cord
periodically, and if damaged, have it
repaired by an authorized service facility.
Inspect extension cords periodically and
replace if damaged. Keep handles dry,
clean, and free from oil and grease.
18)Check Damaged Parts - Before further
use of the appliance, a guard or other
part that is damaged should be carefully
checked to determine that it will operate
properly and perform its intended
function. Check for alignment of moving
parts, binding of moving parts, breakage
of parts, mounting, and any other
condition that may affect its operation.
A guard or other part that is damaged
should be properly repaired or replaced
by an authorized service center unless
indicated elsewhere in this manual.
Table 1
Minimum gauge for extension cords
Volts
Total length of cord in feet
120V
25
240V
50
Ampere rating
more than not
more than
0-6
18
6-10
18
10-12
16
7.5A Electric Blower
50
100
150
100
200
300
AWG
16
16
14
16
14
12
16
14
12
12-16
14
NOTE: Only the applicable parts of the Table
need to be included. For instance, a 120-
volt product need not include the 240-volt
heading.
Figure 1
Method of securing extension cord
APPLIANCE CORD
CORD
SET
FOR ALL DOUBLE-INSULATED APPLIANCES
1) Replacement Parts
When servicing use only identical
replacement parts.
2) Polarized Appliance Connections
To reduce the risk of electric shock, this
appliance has a polarized plug (one blade
is wider than the other} and will require
the use of a polarized extension cord.
The appliance plug will fit into a polarized
extension cord only one way. If the plug
does not fit fully into the extension cord,
reverse the plug. If the plug still does not
fit, obtain a correct polarized extension
cord. A polarized extension cord will
require the use of a polarized wall outlet.
This plug will fit into the polarized wall
outlet only one way. If the plug does not
fit fully into the wall outlet, reverse the
plug. If the plug still does not fit, contact
a qualified electrician to install the proper
wall outlet. Do not change the equipment
plug, extension cord receptacle, or
extension cord plug in any way.
Not
12
recommended
(A) TIE CORD AS
SHOWN
(B) CONNECT PLUG
AND RECEPTACLE
EN
7
Publicidad
