3-In-1 Rocker-Napper
3 Modes of Use:
Rock & Play
INSTRUCTION GUIDE
IMPORTANT: READ ALL INSTRUCTIONS BEFORE USING THE PRODUCT.
KEEP THESE INSTRUCTIONS FOR FUTURE USE AS THEY CONTAIN IMPORTANT INFORMATION.
• The maximum weight of the child of which the
product is intended is 40lbs/18Kg.
• This product contains small parts which are for
adult assembly only. Philips screwdriver required
(not included).
• Remove all packaging materials before use.
Suffocation Hazard.
WARNING: Prevent
serious injury or death:
• Never leave the child unattended.
• This product is not intended for unsupervised or
prolonged periods of sleep.
• Always use restraint system until child is able to climb
in and out of the product unassisted.
• Do not use this product as a "Napper" when the infant
begins to push up on hands and knees.
• Do not use this product as a "Rock & Play" for a child
able to sit up unassisted.
• The upright position ("seat" mode) is only for children
who have developed enough upper body control to
sit up without tipping forward.
• FALL HAZARD: Child's activity may move product, use
only on floor. Never use on any elevated surface.
• SUFFOCATION HAZARD: Never use on a soft surface
(bed, sofa, cushion), as product may tip over and cause
suffocation.
• Never use this product without the "Incline support"
(Figure H, page 8).
• The toy arm is not a carry handle. Never use the toy
arm to carry the product.
• Toy arm should be removed from the seat when child
start to sit independently.
• NEVER lift infant seat with child in it.
• NEVER use infant seat as a car seat.
• Check this product regularly that all assembly fittings
are tightened properly before use.
2
Napper
Versatile Positions
• Do not use if any parts or screws are loose or missing
or if there are any signs of damage or broken parts.
• Do not substitute, modify or alter parts. Contact
the manufacturer if replacement parts or additional
instructions are needed.
• Young children should not be allowed to play
unsupervised in the vicinity of the product.
• Batteries not included. For electronic toy: 3 AAA/LR03
(1.5V). For vibration box: 1 C/LR14 (1.5V).
Other battery information:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickelcadmium) batteries.
• Remove the batteries for long-term storage or
periods of non-use.
• We recommend alkaline batteries for longer battery life.
• Non rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from
the unit before being charged.
• Rechargeable batteries are only to be charged under
adult supervision.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• The supply terminals are not to be short-circuited.
• Check that all contact surfaces are clean and
bright before installing batteries.
• Batteries should be replaced by adults only.
• Exhausted batteries are to be removed from a product.
• Do not burn batteries. Dispose of batteries in a
safe and appropriate manner.
• Install new batteries and retry function before calling
Consumer Relations.
Care & Storage:
1. Washing instructions: All fabrics are machine washable.
• Machine wash cold, Mild cycle
• Do not bleach
• Line drying
• Do not tumble dry
• Do not iron
• Do not dry-clean
2. DO NOT submerge other parts of the product in water.
3. Remove batteries when stored for long periods of
non-use.
4. After washing, make sure that mattress properly dry
before reassembly.
FCC information:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference,
and
2. This device must accept any interference
received, including interference that may cause
undesired operation.
RADIO AND TELEVISION INTERFERENCE
This equipment has been tested and found to
comply with the limits
for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide
reasonable protection against harmful interference
in a residential installation.
This equipment generates uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and the receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
• Changes and Modifications not expressly
approved by the manufacturer or registrant of this
equipment can void your authority to operate
this equipment under Federal Communications
Commission's rules.
For customer service information please visit our website: www.tinylove.com
English
3