Publicidad
Idiomas disponibles
Idiomas disponibles
5.3.2 STARTUP Menu (Using Remote Keypad (HMIR))
The start-up is explained in a very simple way, using the programming features with the existing
parameter groups in the menus STARTUP and BASIC.
After the hardware pre-configuration, the inverter will operate with a different control type.
5.3.2.1 V/f Control Type (P0202 = 0)
Step
Indication on the Display/Action
1
Monitoring mode
„
Press the key ENTER/MENU to enter 1
„
programming mode
3
When the STARTUP group is selected Press the
„
key ENTER/MENU
5
Change the parameter P0317 to "1 - Yes", by using
„
the
key
7
When the desired value is reached, press ENTER/
„
MENU to save the modification
Press the key
for the next parameter
„
9
If necessary, change "P0296 - Line Rated Voltage"
„
Press the key
for the next parameter
„
Step
Indication on the Display/Action
2
The PARAM group is selected, press the keys
„
level of
st
until selecting the STARTUP group
or
4
The parameter "P0317 - Oriented Start- Up" is
„
then selected, press the ENTER/ MENU to get into
the parameter content
6
If necessary, press ENTER/MENU to modify the
„
content of "P0202 - Control Type" for P0202 = 0 (V/f)
8
If necessary, modify the content of "P0298 –
„
Application"
Press the key
„
10
If necessary, change "P0398 - Motor Service
„
Factor"
Press the key
„
Powering up and Start-up
for the next parameter
for the next parameter
MW500 | 31
Publicidad
