Husqvarna DE 110 H Manual De Usuario página 17

WARNING:
approved electrician do all checks of the
electric components.
WARNING:
that you do not make a hole in the filter. Risk
of dust dispersion.
WARNING:
that you obey all local regulations to dispose
the dangerous dust correctly, before and
during maintenance.
Maintenance
Do the filter purge procedure. Refer to
To remove dust particles from the prefil-
ter during operation on page 14 .
Look for signs of wear or damage of the
dust release rubber cone.
Do a check of the power plug and the
power cord.
Look for signs of wear, damage or loose
connections of the controls before the
unit is connected.
Do a check of the hose and the hose
connectors.
Look for signs of wear or damage of the
plastic parts.
Do a check of the lifting eyes.
Make sure that the Longopac is correct
and that it is correctly attached. Refer to
To install a new Longopac bag cassette
on page 14 .
Do a check of the filter purge function.
Do a check of the wheels. Look for
damage and bad connections.
Do a check of the filter seals.
Do the filter purge procedure. If the
suction continues to be not sufficient,
clean the prefilter with water. Refer to
To clean the prefilter with water on page
18 .
1587 - 011 - 06.03.2023
Only let an
Make sure
Make sure
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
Before
Daily
each use
X
X
X
X
X
X
X
X
X
WARNING:
The manufacturer, or an
instructed person, must do a technical
inspection at least annually. The technical
inspection includes an inspection of the
filters for damage, air tightness of the
product and correct function of the
control mechanism. In addition the filtration
efficiency of the product must be tested at
least annually, or more frequently as may
be specified by national requirements. If the
test is not conducted the HEPA filter must be
replaced by a new one.
When
Weekly suction is
low
X
X
X
Each 6 Each 12
months or months or
600 h 2000 h
17