Publicidad
Idiomas disponibles
Idiomas disponibles
16 INSTALLATION
NOTE
• The best location for the electrical conduit is on
the right side of the back wall. Re-route the
electrical cable before installation if the electrical
conduit pipe is longer than 3" (76 mm) and is
centered on the back wall.
1
Turn off electrical power to the unit at the
circuit breaker.
2
Use a Phillips screwdriver to remove the
screw from the junction box cover and
remove the cover.
3
Use a Phillips screwdriver to remove 2 screws
.
a
4
Remove the junction box from the appliance.
5
Insert a strain relief
junction box. Tighten the ring nut
it in place.
through the hole in the
b
to secure
c
6
Insert the electrical cable through the hole in
the strain relief. Tighten 2 screws to secure
the cable.
7
Pull the existing wires through the openings
in the junction box. Tighten 2 screws
reassemble the junction box in the appliance.
8
Pair the white, black, and green wires to the
matching colored wires from the dishwasher.
Then twist on the provided wire nuts
to connect the corresponding wires.
to
d
tightly
e
Publicidad
