Kalorik TKG JK 1029 N Modo De Empleo página 5

BEFORE THE FIRST OPERATION
For the perfect taste, operate the jug kettle with fresh water in order to clean any residue
left from the manufacturing process. When the appliance has cooled down, repeat the
process 3 times with fresh water, before rinsing.
OPERATION
•
Always remove the jug from the power base before filling it or before any operation.
•
Open the lid by pressing its release button and fill the jug with fresh water, paying
attention not to fill under the minimum mark and above the maximum mark in the
kettle.
•
Close the lid by pressing it down until you hear a click. Make sure it closes correctly.
•
Put the jug onto the power base, plug into the wall socket and switch on. The pilot light
will come on, indicating that the appliance is operating. If it does not come on, check
if the kettle is correctly positioned on the base and check if the base is plugged in.
•
The jug kettle will switch off automatically when the water is boiling. However, you can
stop the appliance any time by putting the switch in the off-position.
•
For instant reboiling, wait until the water has cooled down and switch on the
appliance again.
SAFETY CUT-OUT
•
This jug kettle is protected with an automatic safety device which switches the
appliance off when it is accidentally switched on without water. Please bear in mind
that only the thermostat is switched off in case of overheat, whereas the switch stays
in ON-position.
•
In this case, unplug the appliance and wait about 10 minutes for the element to
cool. Then pour in sufficient cold water to cover the element.
•
The kettle may then be used as normal.
CLEANING AND MAINTENANCE
•
Before attempting any cleaning operation, make sure the appliance is unplugged
from the supply socket and fully cooled down.
•
To clean the exterior surfaces, simply wipe over with a soft damp cloth and dry
thoroughly. To remove scale from the inner walls of the kettle you can use a soft
brush.
•
Never use abrasive products.
•
On no account must the jug kettle or its power base be immersed in water.
DESCALING
To remove scale from the jug kettle, use products made especially available for this
purpose. Make sure to use a type recommended for plastic kettles.
5
TKG JK 1029 N