Charging The Battery - Pulsar AXION KEY XM22 Guia De Inicio Rapido

Operation of buttons
Control Condition /
mechanism Operating Mode
ON button Device is
powered off
Display off
Device turned
on, quick menu,
main menu
Up/Zoom Device is
powered on
button
Quick menu
Main menu
Menu Device is
powered on
button
Quick menu
Main menu
Down Device is
powered on
button
Quick menu
Main menu

Charging the battery

AXION thermal imagers are supplied with a rechargeable APS3 Lithium-ion
Battery Pack. The battery should be charged before first use.
Charging the battery
Option 1 (Fig. 2):
• Install the battery (10) into its slot on
the instrument case (14) by aligning
the icons to form a 'dot' on the unit
and the battery (see
• Attach a USB cable (15) to the
microUSB connector (8) on the device.
• Connect the other end of the USB cable
(15) to the mains charger (16) or to a
USB socket connected to another power
sources with rated output of 5V or less.
• Connect the mains charger (16) to the
mains power supply.
Note: The PB8I Power Bank may be used as a charger.
1 short press
Power on the
device
Turn on display Device
Device calibration
Change magnification (Zoom)
Increase parameter
Navigation up, right
Open quick menu
Navigation up
Confirm value, enter menu
options
Operating modes
Reduce parameter
Navigation down, left
Power
adapter
Fig. 4).
Next short Long press
press
Device Power on the
calibration device
Power off the
calibration device
Display off /
device powered
off
PiP on/off
Increase
parameter
Navigation up,
right
Open main
menu
Exit quick menu
Exit menu
options, exit
main menu
Color palettes
Reduce
parameter
Navigation
down, left
16
15
Fig.
2
17
Power
outlet
USB cable
MicroUSB
8
connector
2
ENGLISH