Pulsar AXION KEY XM22 Guia De Inicio Rapido página 6

Option 2 (Fig. 3):
• Insert the battery (10) fully along
the guide rail into the APS* charger
slot (11).
• Point A on the battery and Point B on
the charger should be aligned.
• Two batteries can be charged at
the same time – a second slot is
provided for this.
• Attach the microUSB plug on the USB
cable (15) to the microUSB connector
on the mains device (16). Plug the
device into a 100–240V power outlet
(17).
• Attach the second plug of the
microUSB cable to the socket (12) of
the mains charger (11).
• The LED indicator (13) will light up
battery charge status (see table).
LED Indicator **
* Available separately
** The indicator displays the current level of charge of the battery for 30
seconds when the APS charger is not plugged in. When the power is
connected, the display shows the current status of the battery constantly,
the LEDs additionally flickering to indicate the battery charging process.
3
ENGLISH
Battery charge status
Battery charge from 0% to 10%;
Charger not connected to the mains power supply.
Battery charge from 0% to 10%;
Charger connected to the mains power supply.
Battery defective. Battery should not be used.
Battery charge from 10% to 20%;
Battery charge from 20% to 60%
Battery charge from 60% to 95%
Battery completely charged. Can be disconnected from the
charger.
А
10
А
B
13
LED Indicator
17 16
Power Power
outlet
adapter
Battery
Pack
Fig.
3
Charging
11
base
B
MicroUSB
port
12
15
USB
cable