Electrolux LOC3S40X2 Manual De Instrucciones página 10

1. , - press to set the time.
After approximately 5 sec., the
flashing stops and the display
shows the time.
Turn off the oven and wait until it is cold. Place the accessories and the removable shelf supports in the oven.
7. DAILY USE
WARNING!
Refer to Safety chapters.
7.1 How to set: Heating function
Step 1 Turn the knob for the heating functions
to select a heating function.
Step 2 Turn the control knob to select the tem‐
perature.
Step 3 When the cooking ends, turn the knobs
to the off position to turn off the oven.
7.2 Steam Cooking
Use only water. Do not use filtered
(demineralised) or distilled water. Do not
use other liquids. Do not put flammable
or alcoholic liquids into the water drawer.
1. Set the function
2. Press the cover of the water drawer to
open it.
3. Fill the water drawer with water until the
Tank Full indicator is on.
The maximum capacity of the tank is 900
ml. It is sufficient for approximately 55 -
60 minutes of cooking.
4. Push the water drawer to its initial
position.
5. Set the temperature between 130 °C and
230 °C.
10 ENGLISH
1. Remove all accessories and re‐
movable shelf supports from
the oven.
2. Clean the oven and the acces‐
sories only with a microfibre
cloth, warm water and a mild
detergent.
.
1. Set the maximum temperature
for the function:
Time: 1 h.
2. Set the maximum temperature
for the function:
Time: 15 min.
3. Set the maximum temperature
for the function:
Time: 15 min.
Steam cooking gives good results with
this temperature range.
6. Empty the water tank after the steam
cooking is completed.
Wait for at least 60 minutes after each use of
the steam function to prevent hot water from
exiting the water outlet valve.
CAUTION!
The appliance is hot. There is a risk of
burns. Be careful when you empty the
water drawer.
7.3 Water tank indicator
If you put too much water into the tank, the
safety outlet moves the excess water to the
bottom of the cavity. Remove the water with a
sponge.
7.4 Emptying the water tank
CAUTION!
Make sure that the oven is cold before
you start to empty the water tank.
1. Prepare the draining pipe (C), included in
the package with the user manual. Put
the connector (B) onto one of the ends of
the draining pipe.
.
.
.
The tank is full.
The tank is empty. Re‐
fill the tank.