Imetec E6501 Instrucciones De Uso página 9

the face, ears, neck or skin.
• After use, allow the air styler to cool down completely before putting it away.
PREPARING THE HAIR
• Wash hair as normal and comb removing knots.
• Dry the hair and brush from the roots to the ends.
OPERATION
This styler works with air, which means it works according to the same principle of a common
hair dryer: the hot air comes out from the main body and passes through the holes of the
accessories. When using the styler or while it is heating or cooling, place the appliance on a
smooth and heat resistant surface.
Choose the desired accessory and apply it as shown in the Illustrative Guide. Connect the air
styler to the mains.
ACCESSORIES
Curling tong (7): use this accessory to create tight curls.
• Take a thin lock of hair between your fingers; the thinner the lock, the tighter the curls.
• Act on the lever of the clamp and insert the tip of hair between the cylinder and the clamp
itself.
• Release the clamp and wrap the strand around the tong.
• Switch the air styler ON.
• Wait for the lock to dry as desired before removing it from the tong by releasing the clamp.
• Finish off the style of the curl with your hands.
Round heated brush 32 mm (8)
Use this accessory to create soft waves and curls.
• Take a thin lock of hair between your fingers, the same width as the brush.
• Wrap the lock of hair around the brush no more than twice.
• Set the air styler at the maximum temperature.
• Wait for the lock to dry as desired before releasing it from the brush.
Rectangular heated brush (6)
Use this accessory as a regular brittle brush, which can also be used to revitalize your hair. The
hot air creates a natural hairstyle.
Set the air flow and temperature to the following levels with the (2) button:
0 = OFF
1 = low air flow and low temperature
2 = high air flow and average temperature
3 = cold air shot to set the hair
Cold air shot button (2)
If the appliance is equipped with this button, it can be used to set the styling.
• If this button is pressed while the appliance is on, the hot air is cooled and sets the hair better.
• As soon as the button is released the appliance will blow a hot air flow once again at the
selected level.
When the air styler is not used, unplug the appliance from the socket and store it in a dry and
dust-free place.
Do not wind the power cord around the appliance. Coil it up loosely without
bending it.
IMPORTANT! Switch the appliance off and unplug it from the socket before
cleaning! Make sure all cleaned parts are completely dry before reusing the
appliance!
Cleaning the appliance and accessories
Clean the appliance and the accessories with a damp cloth, when necessary. Do not use
solvents or other aggressive or abrasive detergents. Otherwise, the surface could be damaged.
INSTRUCTIONS FOR USE
USE
STORAGE
MAINTENANCE AND CLEANING
7