Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
Possible causes
Surface burner
The control knob has been
clicks during
left in the Lite position.
operation.
The burners do
Surface burner
not burn evenly.
components and caps are
not assembled correctly
and level.
The surface burners are
dirty.
Very large or
The wrong burner orifice
yellow surface
is installed.
burner flames.
Surface burners
The oven door lock is
light but oven
turned on.
burners do not
light.
The Gas Pressure
Regulator shut off switch
is in the off position.
Control display
Problem
Possible cause
The display goes
A fuse in your home may be
blank.
blown or the circuit breaker
tripped.
Touch controls
There is foreign matter caught
do not respond
between the buttons
when tapped
There is moisture on the
exterior
The lock function is set
98
English
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 98-99
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 98-99
Action
After the burner lights, turn the
control knob to a desired setting.
If the burner still clicks, contact a
service technician.
See page 82.
Clean the surface burner
components. (See page 76.)
Check the burner orifice size. Contact
your installer if you have the wrong
orifice (LP gas instead of natural gas
or natural gas instead of LP gas).
The display will show the Lock icon.
Hold the oven door open and Tap
and hold Settings for 3 seconds. The
oven will beep and the Lock icon will
turn off.
Call a qualified service technician.
Solution
Replace the fuse or reset the
circuit breaker.
Remove the foreign matter and
try again.
Remove the moisture and try
again.
Check whether the lock function
is set.
Oven
Problem
Cause
The oven
There may be an issue
control beeps
with your oven. See the
and displays an
Information codes chart
information code.
on page 104.
The oven will not
The oven is not completely
turn on.
plugged into the electrical
outlet.
A fuse in your home may
be blown or the circuit
breaker may have tripped.
The oven
The oven thermostat
temperature is
needs adjustment.
too hot or cold.
The oven burner
The oven door lock is
will not shut off.
turned on.
The Sabbath function has
been activated.
Oven fan is
The cooling fan is not
making a noise, or
visible, but you will hear
won't turn off.
it running whenever
the electronics get hot
* Slide-In oven
and turn off when the
model only.
electronics are cool.
Action
Turn the burner knob to Off, and
then restart the oven.
If the problem persists, disconnect
all power to the range for at least
30 seconds and then reconnect the
power. If this does not solve the
problem, call for service.
Make sure the electrical plug is
fully inserted into a live, properly
grounded outlet.
Replace the fuse or reset the circuit
breaker.
See page 72.
The display will show the Lock icon.
Hold the oven door open and tap
and hold Settings for 3 seconds. The
oven will beep and the Lock icon will
turn off.
SAb and the time of day will show
in the display. All other controls and
signals will be deactivated. To turn
off the oven only, Turn the burner
knob to off.
To cancel the Sabbath function and
reactivate the controls and signals,
Tap and hold OK for 3 seconds.
This is normal operation to cool the
oven, cooling fan automatically shuts
down when the oven cools.
English
99
2023-01-17 오후 3:02:02
2023-01-17 오후 3:02:02
Publicidad
