Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
Cause
Food does not
The oven controls are not
broil properly in
set properly.
the oven.
The oven door was not
closed during broiling.
The rack has not been
properly positioned.
Information codes
Oven
Displayed
Possible cause
code
This code occurs if the control key is
C-d0
short for 1 minute.
This code occurs if the door lock is
C-d1
mispositioned.
This code occurs if communication
C-F0
between the Main and Sub PBA is
interrupted.
This code occurs if communication
C-F2
between the Main and Touch is
interrupted.
The oven sensor is open when the
oven is operating.
C-20
The oven sensor is short when the
oven is operating.
This code occurs if the internal
C-21
temperature rises abnormally high.
104
English
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 104-105
DOP30T940DS_DG68-01459A-00_EN+MES+CFR.indb 104-105
Action
See page 32.
Close the oven door during broiling.
See the broiling guide on page 45.
Solution
Clean the buttons and make sure
there is no water on/around
them. Turn off the oven and try
again. If the problem continues,
contact a local Dacor service
center.
Turn the burner knob to Off,
and then restart the oven. If the
problem persists, disconnect all
power to the oven for at least
30 seconds and then reconnect
the power. If this does not solve
the problem, call for service.
Restart the appliance.
Displayed
Possible cause
code
The Sub PCB sensor is open when
the oven is operating.
C-22
The Sub PCB sensor is short when
the oven is operating.
The temperature probe sensor is
C-23
short when the oven is operating.
The PCB sensor is open when the
oven is operating.
C-30
The PCB sensor is short when the
oven is operating.
This code occurs if the PCB
C-31
temperature rises abnormally high.
The cooling motor is operating
C-A2
abnormally.
Solution
Turn both the mode and
temperature selector knobs to
Off, and then restart the oven. If
the problem persists, disconnect
all power to the oven for at least
30 seconds and then reconnect
the power. If this does not solve
the problem, call for service.
Turn the burner knob to Off,
and then restart the oven. If the
problem persists, disconnect all
power to the oven for at least
30 seconds and then reconnect
the power. If this does not solve
the problem, call for service.
Call for service
Call for service.
English
105
2023-01-17 오후 3:02:03
2023-01-17 오후 3:02:03
Publicidad
