Publicidad
Idiomas disponibles
Idiomas disponibles
A
B
9.8
LINE CUT-OFF BLADE
This trimmer is equipped with a line cut-off blade (11) on the
guard. The line cut off blade continuously trims the line to
ensure a consistent and efficient cut diameter. Advance line
whenever you hear the engine running faster than normal, or
when trimming efficiency diminishes. This will maintain best
performance and keep line long enough to advance properly.
9.9
ADJUST THE LENGTH OF THE
CUTTING LINE
While you operate the machine, the cutting line gets worn
shorter. You can adjust the length of the cutting line.
1. While the trimmer is running, bump the trimmer head
against the ground.
2. Line is automatically released and the cut-off blade cuts
the excess length.
English
10
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Check
11
regularly that the handles are firmly mounted.
Use only the replacement parts and accessories of the initial
manufacturer.
C
The consequences of improper maintenance, use of
nonconforming replacement components, and the
modification or removal of components may result in
serious injury to user.
10.1
Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
•
•
•
•
10.2
•
•
•
•
•
10.3
For normal use, head disassembly is not necessary.
However, if circumstances require disassembly, follow
these instructions.
11
MAINTENANCE
IMPORTANT
IMPORTANT
IMPORTANT
WARNING
GENERAL INFORMATION
IMPORTANT
Stop the machine.
Remove the battery pack.
Cool the motor.
Use correct clothing, protective gloves and safety glasses.
CLEAN THE MACHINE
Clean the machine after each use with a moist cloth
dipped in neutral detergent.
Do not use aggressive detergents or solvents like "glass
cleaner" to clean the plastic parts or handles.
Keep the trimmer head free from grass, leaves, or
excessive grease.
Keep the air vents clean and free of debris to avoid
overheating and damage of the motor.
Do not spray water onto the motor and electrical
components.
REMOVE THE REMAINING LINE
NOTE
EN
Publicidad
