Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
FAUCET ASSEMBLY/INSTALLATION
- Carefully take out all the parts of the faucet assembly (C). The
faucet is pre-assembled, except for the sprayer head (1).
- Screw the sprayer head (1) onto the gooseneck pipe (2).
- Take the gasket (3), washer (4) and retaining nut (5) off of the
faucet body .
- Place the faucet body carefully through the hole in the sink (B). A
second person may be required to hold the body in place until the
faucet installation is complete .
- From underneath, slide the gasket (3), washer (4) and retaining
nut (5) over the end of the copper pipe and up to the exposed
threaded section of the faucet. Tighten the retaining nut (5)
by hand until it is snug . Using a wrench or pliers, tighten the
assembly .
- Gently tighten the two screws on the retaining nut (5).
Do not over tighten .
- Attach and hand tighten the supply lines (not supplied) onto the
water connectors (6). Use two wrenches to tighten the two ends
together .
NOTE: Failing to use two wrenches can damage the faucet and
void the warranty. Do not overtighten.
- This faucet is equipped with standard 1/2" NPS male thread
connectors that are compatible with standard 1/2" FIP water
supply lines .
Faucet body
Gasket (3)
Retaining nut (5)
Screws
7
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
Gooseneck pipe (2)
Sprayer head (1)
Faucet handle
Sink (B)
Washer (4)
Threaded section
Water Connectors (6)
Water Connectors
1/2" NPS thread (6)
1/2" FIP water supply
line compatible
(not supplied)
CONGLOMKB .COM
Publicidad
