Publicidad
Idiomas disponibles
Idiomas disponibles
2.2
WORKING TIME CONFIGURATION (NECESSARY IF 7/42 CHANNEL TRANSMITTERS ARE USED)
Attention: the following procedure is necessary when using 7/42 channel transmitters (type C).
P1
*
10x
Press the button P1 10 times and keep it pressed for 3 seconds.
The buzzer emits an intermittent sound.
2.3
RADIO CODES DELETION
TYPE OF DELETION
SINGLE RADIO CODE
ALL THE RADIO CODES
* The buzzer will make a beep each time the button is pressed. No more than a second should been pass between the pressing of a key and the next one.
(>3 s)
P1
*
5x
Press 5 times the button P1 and keep it pressed. The buzzer emits an intermittent sound. Press the button of the transmitter relative to
the code to be deleted within 10 seconds. Successful deletion is indicated by a continuous sound of the buzzer.
*
6x
Press 6 times the button P1 and keep it pressed for 10 seconds. The buzzer emits a fast intermittent sound. Release when the sound
becomes continuous.
...
keep it
intermittent
pressed
sound
Command a
manoeuvre using
a memorized
transmitter or
by means of the
wired input.
Press P1 again or wait
25 seconds to quit
the procedure without
saving.
keep it
pressed
(10 s)
14
complete
complete
opening
closing
...
...
LM flashes
Note: this automatic cycle can be stopped with any
command. If working time is exceeded (90 s), the control
unit stops and emits an intermittent sound until any button
is pressed.
...
intermittent
sound
Press the button of the transmitter
relative to the code to delete
...
intermittent
sound
P1
complete
opening
P1
continuous
sound
continuous
sound
Publicidad
