Aritech RF-9011-07-1 Hoja De Instalación página 2

4
Panel
Learned IDs:
all 1 to 11
Repeater
ID 1
Learned
IDs: 2, 7, 8
Repeater
ID 2
Learned
IDs: 3
Repeater
ID 3
Learned
IDs: 4
Repeater
ID 4
Learned
IDs: 9, 10, 11
EN: Installation Sheet
WARNING! Electrocution hazard. To avoid personal injury or
death from electrocution, remove all sources of power and
allow stored energy to discharge before installing or removing
equipment.
You must be free of static electricity before handling circuit
boards. Wear a grounding strap or touch a bare metal surface
to discharge static electricity.
Description
The purpose of the repeater is to receive and retransmit
signals from wireless sensors, wireless keyfobs (only for 63bit
protocol), and other repeaters.
2 / 52
5
Sensor
ID 5
Sensor
ID 6
Sensor
ID 7
Sensor
ID 8
Sensor
ID 9
6
Sensor
ID 10
Sensor
ID 11
Depending on protocol settings, the repeater supports either
433 MHz 63bit sensors, or 433 MHz LoNa sensors, but not
both. See "DIP switch settings" on page 3 for details.
Figure 1: Device layout
A
B
(1) 230 VAC power connector
(2) Battery
(3) Radio antenna for
(4) Status LEDs
(5) DIP switch
Panel
Sensor
ID 5
Learned IDs:
all 1 to 14
Repeater
ID 1
Learned
IDs: 5
Repeater
ID 2
Learned
IDs: 6, 7
Sensor
ID 6
Sensor
ID 7
Panel
Sensor
ID 5
Learned IDs:
all 1 to 12
Repeater
ID 1
Learned
IDs: 5, 6
Repeater
ID 2
Learned
Sensor
IDs: 3, 4, 9
ID 6
Repeater
ID 4
Learned
IDs: 12
PCB front view
PCB back view
transceiver 2
P/N R466-5569-ML • REV C • ISS 18MAR21
Sensor
ID 8
Sensor
ID 10
Sensor
ID 9
Sensor
ID 11
Repeater
ID 4
Learned
IDs: 10, 11, 12
Sensor
ID 12
Repeater
ID 3
Learned
IDs: 13, 14
Sensor
ID 13
Sensor
ID 14
Sensor
ID 7
Sensor
ID 8
Sensor
ID 9
Sensor
Repeater
ID 10
ID 3
Learned
IDs: 10, 11
Sensor
ID 11
Sensor
ID 12
(6) Power supply unit
(7) Diagnostic button
(8) Tamper switch
(9) Diagnostic connector
(10) Transceiver 1
(11) Transceiver 2
(12) Radio antenna for
transceiver 1